|
 |
|
 |
 |
 |
 |
 |
 |
|
 |
    |
 |
- Cut sheet a minimum of 1/8" (3 mm) larger than glass piece.
* Kiln Liner will shrink slightly upon firing.
- Place sheet down on kiln shelf.
- Place piece of art directly on Kiln Liner ™ Fusing Release Paper. If there is more than 1/2” (12 mm) between the edge of the paper and your project, the paper may curl over onto your project. To prevent this, place small pieces of scrap glass on the paper 1/8” (3 mm) from the edge of the paper. Fire the kiln as usual.
- After the glass has cooled, remove it from the shelf and rinse off any paper residue with water if necessary. If removing Kiln Liner from a mold, submerge the fused glass in a dunk bucket to remove Kiln Liner™ from glass.
- Dispose Kiln Liner ™ Fusing Release Paper.
*Protective gloves should be worn when cutting and placing paper on/off kiln shelf.
|
|
