The Aqua-Flow System® is simple and easy to use and does not require any tools for installation. Simply follow the illustrated instructions below.

ASSEMBLY INSTRUCTIONS

	Step 1: Discard sponge
	Step 2: Remove grinder grid.
	Step 3: Remove the white impeller assembly by pulling it up and off the motor shaft.
	Step 4: Install or ensure Quick Fit Bit System or conventional grinding bit is locked securely on grinder shaft.
	Step 5: Snap brush in track on Aqua-Flow System® holder. If right handed, place holder in left hand, with thumb placed in center. Hold brush with right hand. The base of the brush should be placed underneath the lip on the holder. Click in place. Note: the tapered end of the brush should be facing the grinder bit.
	Step 6: Snap in self-locking Aqua-Flow System® holder between grinder bit head and reservoir wall. Brush should touch grinder bit.
	Step 7: Fill reservoir with water. Aminimum of 1/8" must be maintained for the Aqua-Flow System® to operate.
	Step 8: Align grid opening over Aqua-Flow System® brush and grinder bit. Set in place.
	Step 9: Enjoy the pleasure of continuous grinding.

QUICK START INSTRUCTIONS

Once your Aqua-Flow System® has been assembled, capillary action will enable the brush bristles to stay hydrated on subsequent usage. However, to initially expedite the movement of water through brush bristles at the onset of grinding or when the grinder has been idle over an extended period of time, splash a few drops of water over brush bristles. This will allow you to immediately commence grinding.